How to deal with the drainage problem of the washing machine?

The washing machine cannot drain

Check: Check whether the drain pipe is put down, if it is put down, put it down; check whether the end of the drain pipe is immersed in water, and whether it is taken out from the water;

Otherwise: check whether the rubber seal of the drain valve seat is blocked by large or accumulated dirt; check whether the drain pipe is 15cm above the ground; this means that the extended drain pipe is too long or the diameter is too thin.

      The washing machine drains slowly

Check: Check whether the drain valve is blocked by accumulated debris; check whether the drain pipe is bent to cause the drain to block; if it is, you need to remove the material accumulated in the drain valve or replace it with a new drain hose.

      If not: check whether the gap between the drain rod and the rubber valve is too large, adjust the gap between the drain rod and the rubber valve properly; check whether the spring in the drain valve is too long or not elastic, you need to replace the inner spring; if not Other problems indicate that the movement core of the resistance drain solenoid valve is too large or the suction force is reduced.

      Washing machine drain is not clean

Inspection: Check whether the washing machine has poor performance of the water pressure switch in the gas collection room or air leakage in the air pipe, so that the air pressure in the gas collection room becomes small, resulting in the water level in the bucket not reaching the specified position, and the water pressure switch contacts act in advance, resulting in total drainage Time, the phenomenon of unclean drainage.

      In this case, if the water pressure switch is damaged, you should replace the water pressure switch in time; if the air pipe leaks, only use 401 glue to seal the leak.